- Adjust interface to have persistent and non-persistent methods,
to prepare for partial storage in RAM
* PersistentDataStore:
- Cleanup, simplify, and concurrentify
- Tweak stats
- Remove write limit
- Flush to disk on shutdown
- Don't write out what we just read in
- No longer use i2np.udp.forceIntroducers
- Tweak UDP port qualification
- Fix allowing low ports again
- Add option to completely disable NTCP, for those behind nasty firewalls
- Use SSU reachability rather than global reachability for determining NTCP reachability,
since we are now reporting NTCP reachability too
the UPnP device goes away - same as for HTTP POST
- Stuff the port mapping requester into a thread so it doesn't
delay everything for several seconds
- Handle UPnP devices that return IP = 0.0.0.0
- Better HTML output when no IP found
- Tweak logging
- Set Disposer thread name
- Keep the control point running after we find an IGD,
so that we get notifications of it leaving or
coming back or replaced.
- Set Status to OK for local public addresses or UPnP port open
- Allow UDP address changes after we transition to firewalled
- Have NTCP start reporting reachability status, this will
get OK on the console more often and mask UDP problems,
which might be good or bad...
- Fix UDP port configuration
- Reword and rearrange configuration options again
- Rearrange configuration help
- More right-alignment on config
- Prevent Concurrent modification exception in UPnP
- UPnP HTML output tweaks - remove "plugin" references
- Move UDP message failed log from WARN to INFO
- Short-circuit message history call in UDP
SSU reachability is OK. i2np.ntcp.autoip=always for the old behavior.
autoip default is now "true".
i2np.ntcp.hostname=xxx now trumps i2np.tcp.autoip.
- SSU always tells NTCP when status changes.
now defaults to auto; and configured now trumps auto.
Port configuration now does not affect whether inbound
NTCP is enabled - the host configuration alone can do that.
