- Use lifetime average value for job lag
- Change the job lag limit to less than 25ms
- Consider and set the limit of backlogged tunnels to less than 5
receiving a message. Possible workaround for tickets #551, #1075, #1411.
Root cause of problem not yet found.
- Increase threshold for loop throttle, this probably isn't the problem.
- Log tweaks
- Sort introducers in router address, so we won't force a republish
due to a different ordering of the same introducers
- Don't publish an address if we need introducers but don't have any,
so the user won't see a 'firewalled with inbound NTCP enabled' message
caused by change in 0.9.17 removing IP/port from published address
when firewalled. We must now keep a local unpublished address
also, containing the detected IP/port.
- Rescan for devices periodically and when reachability changes (tickets #661, #959)
- Don't put "I2P" in registered protocol name
- Add uptime to UPnP info
- HTML escaping
- Remove static log on Android
- Javadocs and cleanups
PLRIJ interval was 37-50 minutes. Reduce that by 4x,
but for 3 out of 4 times, only publish if something changes,
including cost. 4th time, always publish, as before.
This will hopefully reduce routers getting slammed to
conn limits on a transport.
Tunnels: Cleanup, catch more cases of zero-hop configuration
ClientAppConfig: Start i2ptunnel sooner
Since BuildRequestor won't use a zero-hop exploratory as a paired tunnel
for client builds, it's now safe to start client tunnels
before the expl. tunnels are ready. This will save up to 90 seconds.
- Fix bug that left server acceptor thread running after close
- Add destroy() methods to release all resources when closing a tunnel for good,
particularly the streaming timer threads
- Use COWAL to prevent concurrency problems
- Javadocs
Streaming:
- Don't return null from accept() any more; actually throw
ConnectException as the javadocs have always specified
- Throw ConnectException from accept() if interrupted; previously caught and ignored
- Throw exceptions from ConnectionHandler.accept(), not higher up
- Close ServerSocket when ConnectionManager is shut down
- Synchronize setActive(), clear queue when starting to accept,
better handling of calls that don't change state
- Javadocs
ConfigClientsHelper: Call isPluginRunning() less often
PluginStarter: Simplify detection of active threads
Above changes mostly in support of zzzot plugin implementing ClientApp
and being able to shut down completely so there are no threads
in its thread group, so /configclients will all show status as stopped.
Previously, the I2PTunnelServer acceptor thread and
one or more streaming timer threads would remain.
Full acks were included in the bitfield portion, which
ran over and appeared to be fragments.
Also clean up setting bytes with initial data, for clarity.
